• The u::Lux AddOn CO2+RH+TEMP is a CO2-measuring-module with integrated air humidity and temperature measuring module
• Extends the capabilities of the u::Lux Switch by a CO2 measurement and measures furthermore the relative air humidity and temperature.
• The sensor data is sent to the control directly through the network. An additional sensor input at the control is therefore not required.
• This AddOn is connected through an approx. 25cm long 4-pole cable (included in the scope of delivery) to the u::Lux Switch.
• installation measurements: 55mm x 55mm x 20mm
• CO2 measurement (360ppm until 5000ppm - 0,036 Vol.% until 0,5 Vol.%)
• temperature measurement (-55°C - +125°C)
• air humidity measurement (0% until 100% - non-condensing)

Appropriate u::Lux Switch:
u::Lux Switch RJ45
u::Lux Switch LSA/IDC
u::Lux Switch dS

Further information:
u::Lux AddOns Manual

The assembly of the u::Lux AddOns is always done near a u::Lux Switch. The best results have been achieved with the use of two single-flushmountings assembled below each other or one double-flush-mounting in which the
u::Lux Switch with the u::Lux AddOn is mounted and a double frame is attached. The u::Lux AddOn is connected to the u::Lux NetLink with the supplied cable (approx. 25cm). Frames are not included in the scope of delivery - check overview cover frames)